ENOX Overhead Door Closer TS - 700

ENOX Overhead Door Closer TS - 700
ENOX Overhead Door Closer TS - 700
ENOX Overhead Door Closer TS - 700
ENOX Overhead Door Closer TS - 700
CUTOUT DETAILS - ENOX Overhead Door Closer TS - 700
CUTOUT DETAILS - ENOX Overhead Door Closer TS - 700

ENOX™ Door Closer TS - 700 with selectable closing force EN 2/3/4

Applicable door width EN 2/3/4

Door Closer with selectable closing force EN 2/3/4

Features of ENOX Overhead Door Closer TS - 700

  • Hydraulic closing with two stage closing control.
  • Closing force 2/3/4 according to EN for door width up to 1100 mm adjustable by moving the door closer.
  • With standard arm.
  • Same version DIN left and DIN right.
  • Mounting height only 53 mm.
  • Maximum Door Weight - 80 kgs.
  • Maximum Door Width - 1100 mm.
  • Maximum Angle of Opening - 180°.
  • Tested - 500,000 Cycles.
  • Finish - Silver.

Dimension detail of Hinge Side

DIN left-door, DIN right laterally reversed

Standard mounting, hinge side

Dimension detail of Hinge-opposite Side

DIN left-door, DIN right laterally reversed

Head mounting, hinge-opposite side

Closing Force EN 2 / 3 / 4

Standards and Classification

Standards relevant to the architectural hardware industry

Standards

There are two standards currently in existence for door closing devices:

EN 1154: 1997 - Mechanical closers

EN 1155; 1997 - Electronically controlled closers

These standards are shown in summary below in detail at the back of this catalogue. Attention should be paid to Digit 3, which deals with the power size and door width. Where applicable we have shown the relevant classification code using DHF graphic icons in this section.

Scope - The standard covers all controlled surface mounted, concealed,or transom mounted closers as well as both single and double action floor springs.

Classification


Digit 1 - Category of use

For all internal and external doors for use by the public, and others,with little incentive to take care, i.e. where there is some chance of misuse of the door.

Grade 3 : For closing doors from at least 105° open

Grade 4 : For closing doors from 180° open

Note 1 : Grade 4 classification assumes standard installation according to the manufacturer's instructions.

Note 2 : For applications subject to extremes of abuse, or for particular limitations of opening angle, door closers incorporating backcheck function or provision of a separate door stop should be considered.


Digit 4 - Fire behaviour

Two grades of fire behaviour are identified for door closingdevices manufactured to this standard:

Grade 0 : Not suitable for use on fire/smoke door assemblies

Grade 1 : Suitable for use on fire/smoke door assemblies,subject to satisfactory assessment of the contribution of theemergency device to the fire resistance of specifiedfire/smoke door assemblies.


Digit 2 - Number of test cycles

Only one test duration is identified for the door closing device manufactured to this standard: Grade 8: 500,000 cycles


Digit 5 - Safety

All door closers are required to satisfy the Essential Requirement of safety in use contained in the Construction Products Directive by the EU. Therefore only Grade 1 is identified


Digit 3 - Test door mass/size

Seven test door mass grades and related door closer power sizes are identified according to below table of this standard. Where a door closer provides a range of power sizes both the minimum and maximum sizes shall be identified.


Digit 6 - Corrosion resistance

Five grades are identified according to EN 1670:

Grade 0 : No defined corrosion resistance

Grade 1 : Low resistance

Grade 2 : Moderate resistance

Grade 3 : High resistance

Grade 4: Very high resistance

Interested in this product?

Contact us to order